Ultimate Technology 600 POS Uživatelský manuál stáhnout pdf (Strana 67)

User’s Manual

DVR-4TN/8TN/16TN/16TS/16TT Series

SPECO TECHNOLOGIES 01/08

<Network restart>: This message shows the user if the DVR 1 was able or

NOT able to:

1. Either use the IP address that the user entered manually

2. Or to see if the DVR 1 can be assigned a dynamic IP address from the

router using DHCP

The flowchart is illustrated in Fig. 5.1.

Figure 5.1

<ezRouter setting>: When the IP address is obtained and assuming that you

have set the ezRouter correctly (Please refer to Router Setting

section to

setup the ezRouter), the DVR 1 will then connect to the router to see if the

DVR can automatically setup the router. The flowchart for this message (Fig.

5.1) is the same as <Network restart>, the only difference is that the DVR 1

will connect to the router to see if the DVR 1 can change the settings of router.

Note: Sometimes the “X” symbol may be displayed for ezRouter

setting because there are too many ports opened in the router. Close

the redundant ports and re-do the ezRouter setting. The average ports

that can be opened in a router are about 10 to 30 ports depending on

the router that you use.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 147 148

Žádné komentáře

Ultimate Technology 600 POS Uživatelský manuál Strana 67